Blog and advice

Irrigation advice and guides

Practical notes from our engineers on watering, controllers and keeping a system alive through a London and Surrey year. If a question is not covered here, ask us and we will answer it properly.

How much water does a London garden actually need?

One deep soak beats five light sprinkles. Here is what drives demand, and why a schedule set in April is wrong by July.

What drives demand

Water use in a garden follows the weather, not the calendar. Sun, wind, humidity and temperature all move together, and a warm breezy week in May can pull more water than a cool damp one in August.

The other half is the site itself. Clay soil holds water and needs longer, less frequent cycles so it can soak in without running off. Sandy soil in parts of Surrey drains quickly and wants shorter cycles more often. Slopes, shade, mulched beds and exposed roof terraces all shift the answer.

Reading your own soil

Push a finger or a trowel into the border after watering. If it is dry 50mm down the following morning, the cycle was too short. If it is still saturated, you are watering too often and the roots are staying shallow.

Lawn tells you the same thing: footprints that stay visible, a dull grey-green colour and blades that spring back slowly all mean it is time to water, not that it is time to panic.

Why the controller matters more than the nozzle

A weather-linked controller adjusts run times as the forecast changes, which is far more effective than any single head choice. Zones run one at a time, at the pressure the system was designed for, and the schedule moves with the season.

Getting this right is the bulk of the water saved over a year. A smart controller on an average domestic system cuts waste quietly, week after week, without anyone touching it.

A spring start-up checklist you can do yourself

Before you switch the system on for the season, these checks catch the damage winter left behind.

Before you switch on

Walk the garden and look for heads that are buried, capped, mown over or pushed out of line by frost. Clear soil and mulch away from the top of each head. If the system was drained in autumn, confirm the drain valves and test cocks are closed again before water goes in.

Open the supply slowly. A sudden rush into empty pipework can move debris into the valves and nozzles, which is the most common cause of a zone that will not shut off properly afterwards.

Zone by zone

Run each zone for a couple of minutes and watch every head. You are looking for even coverage, no geysers, no sunken turf and no heads spraying onto paths, walls or windows. Note the faulty ones rather than digging mid-season.

Check the valve box too. Water sitting in the box after a zone finishes points to a leaking diaphragm or a stuck solenoid.

Controller and schedule

Update the date and time first, then the schedule. Early season cycles should be shorter than midsummer, and after a wet spring many zones need little at all for the first few weeks.

If your controller is weather-linked, check it is still connected to Wi-Fi and pulling a forecast. A controller that lost its connection in November is running blind by April.

What to leave to us

Pressure testing, valve rebuilds, flow-meter faults and anything inside the controller wiring are worth a professional visit. A spring start-up covers all of it in one pass, and it is far cheaper than diagnosing a burst in July.

Sprinklers not working: the first five things to check

Work from the power outwards. Most “dead” systems are one of these five, and four of them need no tools.

Power and controller

Confirm the controller has power and is not showing a fault. Check the transformer, the fuse and whether the display is asking for a date again: a power cut resets many controllers and leaves them paused.

If one zone runs and others do not, the controller is fine and the problem is downstream. Test a zone manually from the controller before going near the garden.

Rain sensor

A rain sensor that is stuck closed will hold the whole system off, even in a drought. Most have a bypass switch or a test spindle on the side. If bypassing it brings the system back, the sensor is the fault.

The valve

Water in the valve box, a solenoid that does not click, or a zone that stays on after the controller stops are all valve symptoms. A stuck solenoid can often be freed by hand; a torn diaphragm needs replacing.

Pressure and flow

If heads barely lift, check whether anything else on the supply is running and whether a shut-off valve was closed over winter. A zone that has never performed well is usually a design issue rather than a fault: too many heads on one run, or pipe that is too small for the distance.

When to call us

Call when a fault repeats, when you cannot find the valve box, when water is pooling, or when the system was installed by someone else and you have no drawing. Diagnostics on site takes under an hour and saves a lot of guesswork.

Hydrawise, or a plug-in timer?

Smart controllers are not always the right answer. What weather-linked control adds, and when a simple timer is genuinely enough.

What weather-linked control does

A Hydrawise controller holds a schedule for each zone and adjusts it against the local forecast and recent rainfall. In practice that means less watering in a wet fortnight and more in a hot one, without anyone editing a dial.

It also tells you something. Flow monitoring can flag a burst pipe or a stuck valve, and zone history shows what actually ran rather than what was programmed.

Where a simple timer is fine

A small, well-planted garden on a reliable mains supply, with a couple of drip zones and someone at home who notices problems, does not need an app. A basic controller does the job and costs less to replace when it eventually fails.

The same is true where there is genuinely no Wi-Fi and no mobile signal: a system that depends on a connection it cannot hold is worse than a timer.

Getting a connection to the garden

Where signal is marginal we fit a 4G controller or extend the Wi-Fi to the plant room. It is worth checking before you buy, because a smart controller with no connection is just an expensive timer.

How we decide

It comes down to the number of zones, how visible the planting is, whether anyone is on site to notice a fault, and how much the garden matters in a dry spell. We will tell you when a simpler controller is the better buy.